1 minute read

One breadboard is often not enough for a bigger circuit. The good news is that breadboards are made to be joined together, and you can share the same power supply between them. For this you will need:

  • 2 breadboards
  • Power supply already connected to the first breadboard
  • 2 jumper wires
  • 1 LED (for testing)
  • 1 resistor (220 Ω works well, anything up to 1 kΩ is fine)

Step 1- Join the two breadboards

Look at the sides of your breadboards. On one side you will see small tabs sticking out, and on the other side you will see slots going in. They are made to fit each other, just like puzzle pieces or building blocks.

diagram

you are going to fit them together.

diagram

Step 2- Share the power supply

Our first (top) breadboard already has the power supply connected to it. Joining the boards does not pass the power to the bottom one, so we connect the power rails with jumper wires.

  1. Connect one jumper wire from the ground rail of the top breadboard to the ground rail of the bottom breadboard.
  2. Connect the other jumper wire from the HIGH supply (+5 V) rail of the top breadboard to the HIGH supply (+5 V) rail of the bottom breadboard.

diagram

Make sure ground goes to ground and HIGH goes to HIGH. If you cross them, your circuit will not work, and it can damage your components.

Step 3- Test the connection

We can check that the power reached the bottom breadboard with a resistor and an LED. This is the same LED setup we used in the gate practicals.

  1. Connect one leg of the resistor to the HIGH supply rail of the bottom breadboard.
  2. Put the other leg of the resistor in any free column on the bottom breadboard. Holes in the same column are connected together.
  3. In that same column, place the longer leg of the LED.
  4. Connect the shorter leg of the LED to the ground rail of the bottom breadboard. If the LED lights up, the power supply is reaching the bottom breadboard, and your two breadboards are connected correctly.

diagram

Lets take a cleaner look…

diagram

This way you can get power supply between multiple breadboards!